Peugeot 308 Key Fob Replacement
Peugeot’s 308 may be somewhat old-fashioned however it’s still appealing. It’s not the most luxurious car in its class and an Ford Focus or Volkswagen Golf will shield you from surface imperfections – but it’s still a pleasant and comfortable drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is ongoing or continuous these tips will aid.
Water Damage
If you accidentally drop your key fob into a puddle or it is wet while kayaking, canoeing, rafting or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry container whenever you are outside or perform things that expose it to a lot of water.
It is also important to make sure that the fob is completely dry prior to opening it and re-using it. If you detect any odors emanating from the fob (such as industrial fluid or windshield washer fluid) it is a indication that it’s submerged.
A wet circuit board can cause the battery’s charge to drop its energy or even explode. If you can get your 308 keyfob out of the water and turn it upside up and shake as much water out as you can prior to opening the casing. Take the battery out, and then clean the circuit board with a cotton swab that has been dipped in 90-percent alcohol.
Other causes why your Peugeot 308 remote entry keyless system may not work include a dead coin cell battery or receiver module malfunction signal interference or a faulty chip. If none of these are the problem, you can try resetting the system by removing the 12 volt battery for about 15 minutes.
Dead Coin Battery
peugeot 207 car key replacement cars come with a remote-start system that allows the driver to start the car from afar, warming up or cooling down the vehicle prior to stepping inside. This feature is extremely useful, especially during winter’s cold and chilly months. However, sometimes the remote stop system stops working due to a variety of causes, such as the battery in the coin is dead.
A coin-shaped battery in the key fob will last a time of two to four years, based on how frequently it is utilized and where it was purchased. Its use-by date is typically written on the package or written in the manual.
If the key fob has stopped working after exposure to water that is clean it is recommended to remove the battery, then clean the chip using a paper towel and isopropyl Alcohol, then dry it completely before replacing it. If the key fob was exposed to salty or soapy water, it may have caused the chip to become damaged. You’ll need to replace it.
If you’re not certain the battery is defective, you can test the voltage with an instrument set to the vehicle’s voltage range and connected to the plus and minus terminals. If the voltage is less than 12-13 volts, you must replace the battery. You can also try to reset the on-board computer by disconnecting the battery with 12 volts for a couple of minutes, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should now start.
Faulty Receiver Module
If you’re not getting the “Key Detected” message on your dashboard, then it’s possible that your receiver module has been afflicted with a fault. It’s the part that transmits an alarm to the car when your key fob is activated, that also acts as an immobiliser and prevents it from starting unless the correct key is present.
This could be due to a variety of causes, such as water damage or simply the aging process. If your peugeot 407 key 308 key fob has been exposed to dirty tap water, for example the chip that is located inside is damaged. In this case you’ll have to take off the battery and thoroughly clean it with isopropyl alcohol, or electronic cleaner. Once it’s dry you can put the battery back in and test it again.
If the issue continues to persist then it’s a good idea to see an area Peugeot 107 key Programming specialist or locksmith. They’ll be able to employ a diagnostic tool identify the problem and fix it.
It is stressful to lose your Peugeot car key. A reputable auto locksmith can solve the issue in a matter of minutes. They can cut a new key and then program it into your vehicle, so you can get back off the road as quickly as possible. Click here to find a local locksmith near you.
Faulty electronic chip
The electronic chip in the Peugeot 308 key fob plays a vital function in the remote control system. If it gets damaged, your car may not start or get a message saying “anti-theft active”. In this scenario the only option is to replace the key. Fortunately, professional auto locksmiths are able to provide this service in the shortest amount of time.
The chip in the chip of your Peugeot 308 key fob can be damaged due to sweat, water damage dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, it is recommended to clean it immediately. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. After that, you should let the battery dry completely.
Sometimes, a key fob can cease to function due to radio interference. This can be caused when other devices use the same frequency as your Peugeot keyfob. It could also be caused by bad weather or objects that are in the vicinity of the vehicle. If you encounter this issue you should visit an Peugeot dealership.
The peugeot 206 replacement key 207/308 Key Fob is very delicate and requires special attention. It is crucial not to drop or throw the key fob. If you lose it, try to locate it as quickly as possible. You can reset the on-board computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative first, and then the positive.